MCB 101 - Advanced I / O option
Expands the number of freely programmable Control inputs and outputs around the following I / Os:
- 3 digital inputs opto-decoupled 0 - 24 V.
- 2 analog inputs 0 - 10 V.
- 2 digital outputs NPN / PNP switchable 24 V
- 1 analog output 0/4 - 20 mA

The kit includes fasteners, 8m cable, gasket and a blind cover to ensure IP55/ 66
after the LCP has been mounted elsewhere. The 8m cable is open in one end and the
connector block is included in the package. No LCP included.

This is only the top part of the kit - If you need a kit with both top and bottom please order 130B1122

This is only the top part of the kit - If you need a kit with both top and bottom please order 130B1123

MCA 120 PROFINET interface
-Supports operation on PROFINET network with extensive properties
-DCP support for easy setting u. Communication parameters via the PLC
- On Board web-Page with Drive Status
- Parameterization with the MCT10 software
- 2 port version, reduced external hardware

MCB 112 PTC - thermistor relay MS220DA In connection with ATEX certified explosion-proof
motors for full motor protection. Certified PTC sensors are the sole protection required.
Integrable module with ATEX-compliant full thermal motor protection
1 PTB-certified PTC thermistor input
1 switch-off signal for using the Safe Stop function
1 logic output for error identification

I / O expansion for FC 100, through modular technology easy to retrofit. Analog inputs/outputs
galvanically isolated.
Expands the analog inputs / outputs by:
3 analog inputs: 0 ... 10V / Pt1000 / Ni1000
3 analog outputs: 0 ... 10V
Time switch (RTC backup): lithium cell for 10 years

Easy to fit. Upgrades built-in cascade controller to operate up to 8
pumps and provide more advanced pump control in master/follower mode.
Supports combination of multiple variable speed and fixed speed pumps,
as well as configurations with pumps of differing capacity (mixed pump
control). The additional 7 digital inputs and the 24-V DC connection to
the drive enable flexible adaptation to the application. The same
cascade controller hardware is compatible with the entire power range up
to 2 MW.

USB extension kit for FC 300 cable length: 350mm for the housing size:
B2, C1 and C2 screw connection M 25

USB extension kit for FC 300 cable length: 650mm for the housing size: B2, C1 and C2
screw connection M 25

Adds 7 digital inputs and 2 analog outputs for increased flexibility. 4
SPDT relays. Meets NAMUR recommendations. Galvanic isolation capability.

The kit includes fasteners and gasket. No LCP and no cable included.

Protects the motor from being overheated by monitoring the temperature
of bearings and windings in the motor. Three self-detecting sensor
inputs for 2 or 3 wire PT100/PT1000 sensors. One additional analog input
4–20 mA.

Cover for housing size B3 MCF 101 NEMA1 / IP21

IP21 top cover for enclosure B3
Product group: R1

IP21 cover for enclosure B4
Product group: R1

IP21 top cover for enclosure B4
Product group: R1

IP21 cover for enclosure C3.
Product group: R1

IP21 top cover for enclosure C3
Product group: R1

IP21 cover for enclosure C4.
Product group: R1